SKF TMBH 1 Portable Bearing Heater
Application
The SKF bearing heater TMBH 1 is intended for heating rolling bearings with an inner diameter up to 80 to 100 mm (3 - 4 in) and a maximum corresponding weight of 4 - 5 kg (9 - 11 lb). Other ring-shaped metal components forming a closed circuit such as gears, pulleys, bushings and shrink rings can also be heated. This apparatus uses a patented method of heating based on high frequency induction.
Principle of Operation
An induction heater can be compared with a transformer using the principle of a primary coil with a large number of windings and a secondary coil with a few windings on a mutual core. The input / output voltage ratio is equal to the ratio of the windings, while the energy remains the same. In the case of the SKF Bearing Heater TMBH 1, the primary coil is connected to a high frequency power supply. The bearing acts as a short-circuited single-turn secondary coil through which a low AC voltage flows at high amperage, thus generating a lot of heat. The heater itself as well as the clamp remain at ambient temperature.Due to different physical proportions the inner ring of a bearing will heat up faster than the outer ring, thus reducing the radial internal clearance. As long as the recommended temperature of 110 °C (230 °F)is not exceeded, this does not threaten to damage the bearing. Both greased and sealed bearings can be heated without risk of damage.
Demagnetisation
The high frequency current used, which creates low flux density in the bearing, means that no magnetisation will take place, thus avoiding the necessity for demagnetisation.
Safety Features
This bearing heater is equipped with the following safety features:
- Input current fused at 5 A
- Output current restriction to the clamp at 1,2 A at 400 V
- Internal thermal overload protection
In the temperature mode the heater will switch off if the temperature probe does not register a temperature increase of 1 degree every 15 seconds.
A short circuit on the clamp windings or cable will not inflict any risk to the user.
Looking for Laser Shaft Alignment?
Click Here for SKF's TKSA20 Laser Shaft Alignment System - Only $2895.00 - Best Value For Small to Medium size couplings
Weight | 15.000000 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Specifications |
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Manufacturer | SKF | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
MPN | TMBH 1 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Manufacturer Warranty | 1 year |