High Voltage CDS-2010U Cable Fault Locator Surge Generator 20kV
High Voltage CDS-2010U Cable Fault Locator Surge Generator 20kV- With its 20kV ouput, the CDS-2010U is good for fault locating cables rated up to 35kv, having a line to ground voltage of 20kV. The high burn current of 400mA can be used to condition a fault to reduce its arc over voltage to permit thumping at a lower and less damaging voltage level, yet still at full energy. The CDS-2010U can thump a cable at just 5kV yet deliver 1000 joules. Find your fault without making more.
High Voltage CDS-2010U Cable Fault Locator Surge Generator 20kV
With cable diagnostic testing becoming more common, the need for fault locating will rise. If a cable cannot withstand the test voltage, failure will occur, requiring fault locating. If you’re in the market for a thumper, why not get one with a VLF hipot built-in to test the AC integrity of the cable following repair.
There is no better thumper. The CDS-2010U offers the complete package: three full joule output voltages, three variable hipot outputs, the highest burn current, rapid discharge rate, tdr/radar ready, and its rugged design holds up to years of use. Another plus: all HVI Thumpers use EPR high voltage output cable rather than XLPE. EPR stays flexible in cold weather.
HVI produces some of the most powerful and full featured fault locators available. All the features needed for efficient fault finding can be found in our thumpers, don’t settle for less:
• Three full joule output voltage settings
• Three fully variable hipot output voltages
• The highest Burn current available
• Internal Arc Reflection and Current Impulse filter
• Compatable with nearly all TDR/radar models
• The most rugged and reliable design
5 kV – 35kV Cable Systems
Ideal for Coops, Small Municipals, IOU URD and Industrials
| Weight | 245.000000 |
|---|---|
| Specifications | Features CDS-2010U |
| size | 27”w x 27”d x 48”h |
| Manufacturer | High Voltage Inc. |
| MPN | VT33(F) |
