SMC PTE-100-C PRO Current and Voltage Relay Test Set

The PTC-100-C Pro can Test the following IEEE Relay Functions:

2 Time-delay starting relay ✓
21 Distance 1Ø ✓
24 Volts / Hertz ✓
25 Synchronizing ✓
27 AC / DC Undervoltage ✓
32 1Ø directional power ✓
37 / 76 DC Under / overvoltage ✓
40 Loss of field ✓
46 Reverse phase ✓
46N Negative Sequence Overcurrent ✓
47 Reverse phase voltage ✓
49 Thermal relay ✓
50 Instantaneous Overcurrent Relay ✓
51 Timed Overcurrent Relay ✓
59 Overvoltage Relay ✓
64 Ground detection relay ✓
67 Directional overcurrent relay ✓
67N Ground directional overcurrent relay ✓
78 Phase angle / Out of step relay ✓
79 Reclosing relay ✓
81 Frequency relay ✓
82 DC reclosing relay ✓
91 Directional voltage relay ✓
92 Directional voltage & power relay ✓
94 Tripping relay ✓

• Variable Output Current to 250A in Four Ranges
• Variable AC Output Voltage to 250V (4A)
• Variable DC Output Voltage to 350V
(2.8A)
• Built-in timer with 1ms resolution
• Output power: 1000VA
• Auxiliary DC power supply to
250V
• Electronic protection in all
outputs

This compact, 30-pound unit packs a 1000VA punch in its current
output taps.This unit is transformer based with a variac control.

It can also measure phase-angle between output
current & compliance voltage (impedance angle of
load), between output current & an external voltage,
or between an external current and voltage. On-board
timer will display in seconds or cycles, and can be
activated with a contact open/close or voltage
applied/removed. Timer can also be used to measure
duration of above states. There are also many preset
features on the unit that can be utilized, including an output
current limit and/or a maximum time duration for the output to protect
the device being tested. It also features "Imax", which enables unit to capture
maximum current output when testing instantaneous trip points. Unit can be operated
manually, or it can be computer controlled to meet application requirements.

APPLICATIONS
- Testing of overcurrent and minimum/maximum voltage relays.
- Testing of overcurrent directional relays (with load option).
- Testing of reclosing devices (with external timer option).
- Testing of dc relays.
- Testing of MCB’s.
- Verification of the knee point in current transformers.