INSULATED TOOLS

The following definitions apply to terminology used in the Electrical Safety-Related Work Practices standards at 29 CFR 1910.335. Tools are hand-held, manually-operated or motor-operated, implements for performing or facilitating mechanical operations. Handling equipment is equipment which is held or operated with the hand. Insulated means separated from other conducting surfaces by a dielectric substance or air space permanently offering a high resistance to the passage of current and to disruptive discharge through the substance or space.

Insulated tools are intended to provide protection against accidental contact with charged energized circuits. For safety purposes PPE ARC FLASH does not recommend working on LIVE Electrical or energized circuits.

Note: Tools are a specific category of handling equipment. When any tool or handling equipment is said to be insulated, it is understood to be insulated in a manner suitable for the conditions to which it is subjected [Reference-ANSI/IEEE Std 100-1984-IEEE, Standard Dictionary of Electrical and Electronics Terms). Otherwise, within the purpose of this referenced definition, tools and handling equipment are considered uninsulated.

Use and care for insulted tools:

Keep tools clean and dry

Inspect insulation prior to each use

If you doubt the integrity of the insulation, destroy the tool or have it re-tested

Follow the manufacturer's temperature recommendations for use

Have a qualified person inspect and re-certify tools annually for safe use

Use other personal protective equipment as necessary

Lifetime Guarantee on all Insulated Tools & Two Year Warranty on Coating

• Insulated Tools are engineered for live work up to 1000 Volts
• Insulated Tools conform to the newest OSHA regulations, including 29CFR1910.269 and 29CFR1910.331-335
• Protect your employees from dangers of flashover, shocks and burns!
• Every tool is individually proof-tested and visually inspected for defects.
• Each tool meets or exceeds the standards set by IEC900 and ASTM- F1505 as well as VDE0680.
• Outer coating is flame retardant & non-corrosive; inner coating is fully bonded to the tool.
• Tools are manufactured from special high quality chrome vanadium.

Sub Categories: