Fluke 434 Series II 3-Phase Energy Analyzer Kit with 3000 Amp Thin-Flex Probes

The new 434 Series II Energy Analyzer offer the best in power quality analysis and introduce, for the first time ever, the ability to monetarily quantify energy losses.

• Energy loss calculator: Classic active and reactive power measurements, unbalance and harmonic power, are quantified to pinpoint true system energy losses in dollars (other local currencies available).
• Power inverter efficiency: Simultaneously measure AC output power and DC input power for power electronics systems using optional DC clamp.
• PowerWave data capture: capture fast RMS data, show half-cycle and waveforms to characterize electrical system dynamics (generator start-ups, UPS switching etc.).
• Waveform capture: capture 100/120 cycles (50/60Hz) of each event that is detected in all modes, without set-up.
• Automatic Transient Mode: capture 200 kHz waveform data on all phases simultaneously up to 6 kV.
• Fully Class-A compliant: conduct tests according to the stringent international IEC 61000-4-30 Class-A standard.
• Mains signaling: measure interference from ripple control signals at specific frequencies.
• Troubleshoot real-time: Analyze the trends using the cursors and zoom tools.
• Highest safety rating in the industry: 600 V CAT IV/1000 V CAT III rated for use at the service entrance.
• Measure all three phases and neutral: With included four flexible current probes with enhanced thin flex designed to fit into the tightest places.
• Automatic Trending: Every measurement is always automatically recorded, without any set-up.
• System-Monitor: Ten power quality parameters on one screen according to EN50160 power quality standard.
• Logger function: Configure for any test condition with memory for up to 600 parameters at user defined intervals.
• View graphs and generate reports: With included analysis software.
• Battery life: Seven hours operating time per charge on Li-ion battery pack.