Myron L 9P Ultrameter III Water Quality Meter

Myron L 9P Ultrameter III Water Quality Meter

The 9P adds the ability to perform in-cell alkalinity and hardness titrations  either as stand-alone measurements or as part of an LSI calculation. Alkalinity,  hardness, pH and temperature values can be manipulated in the LSI calculator to  predict the effect of changes on water balance. The 9P adds the ability to perform in-cell alkalinity and hardness titrations either as stand-alone measurements or as part of an LSI (Langelier Saturation Index) calculation.
Alkalinity, hardness, pH and temperature values can be manipulated in the LSI calculator to predict the effect of changes on water balance.
The Hardness titration, LSI Titration and LSI Calculator functions allow you to set the hardness unit preference to either grains of hardness or ppm CaCO3.
Accurately calculate a saturation index value of a specific solution to determine whether the solution is balanced, scaling or corrosive.
The Ultrameter III features the ability to convert Oxidation Reduction Potential measurements from mV to parts per million (ppm) free chlorine.
Like the Ultrameter II, the Ultrameter III delivers exceptional accuracy of ±1% of reading (±.1% at calibration point).

• Conductivity: 0–9999 µS/cm 10–200 mS/cm in 5 autoranges
• Temperature: 0–71°C/32–160°F
• Resistivity: 10 KΩ–30 MΩ
• TDS: 0–9999 ppm 10–200 ppt in 5 autoranges
• pH: 0–14 pH
• ORP: ±999 mV
• Free Chlorine: 0.00–10.00 ppm (5<pH<9)
• Alkalinity Titration: 10-800 ppm
• Hardness Titration: 0-1710 ppm 0-100 grains
• LSI Titration: -10 to +10