Mitchell PLEP01 Tool and Appliance Hipot Tester - 2500 Volt Output

$625.00
Mitchell Part Number
MMJ-PLEP01
Availability
Typically in stock, Call if Urgent
Quick overview

The Mitchell Model PLEP01 Tool and Appliance Hipot Tester checks the integrity of corded power tools, corded appliances or extension cables for cracks or other insulation defects as well as ground continuity on any exposed metal parts.

Hipot Tester - Quickly Check Corded Tools for Proper Grounding and Cord Insulation Damage

• Verify compliance with OSHA and NEC re-quirements
• One button checks ground wire continu-ity and verifies dielec-tric strength
• Receptacle is provided for exten-sion cords to allow them to be tested for hi-pot and ground continuity
• Used to verify proper oper-ation of electrical equipment used in work place and on construction sites
• In event of a failure both operator and product are protected with automatic shut-off
• Ensures that primary circuit power and ground conductors are properly wired and connected for safe operation
• Also applies a high-voltage potential between power and ground conductor to make sure that no unintentional leakage or arcing paths exist between power and ground
• It is non-destructive to the equipment under test, and can be accomplished in a short time
• The test consists of a ground continuity check and a high voltage check

 

OSHA’s (1926.404)
Assured Equipment Grounding Program

WASHINGTON–The employer must establish and implement an assured equipment grounding conductor program. All cord sets and equip-ment connected by cord and plug that are available for use or used by employees must be in compliance. Cord sets and equip-ment connected by plug and cord must be inspected visually before use each day. The are also required to be grounded and must have a continuity test performed. Employees must not be allowed to use any equipment that has not met the requirements.

More Information
Weight 5.000000
Product Includes tester with integrated ground check probe and power cord
Specifications

Output test voltage:  500, 1000, 2500 volts AC
Leakage current: 5 mA preset
Pass / Fail criteria: Ground continuity: 3ohm ±5% (metal cased only); Leakage current: Internally adjustable 0.5 to 5mA;
Dielectric breakdown: Separate high frequency detection circuit for breakdown spike detection.

Power Supply 120 VAC 60 Hz
Manufacturer Mitchell Instrument
MPN PLEP01
Manufacturer Warranty 1 Year
Mitchell Catalog Number 7ZEP01, 8ZEP01, 9ZEP01, WBEP01,
You're reviewing: Mitchell PLEP01 Tool and Appliance Hipot Tester - 2500 Volt Output
Your Rating