UEI Eagle2X Extended Life Combustion Analyzer Model C155

$0.00
Mitchell Part Number
UNJ-C155
Manufacturer
Availability
Out of Stock
Quick overview
Discontinued
  • The Eagle X also offers a new Xtended Life CO Sensor, which has a life expectancy of 5 years and is backed by a 5 year limited warranty. Reducing the sensor’s replacement frequency helps to minimize the analyzer’s cost of ownership to just the CO sensor calibration. Most manufacturers recommend annual calibration.
  • The new EOS CO2 sensor takes direct CO2 measurements and calculates the O2 level. This exclusive EOS sensor has a 5 year limited warranty and an unmatched industry-leading life expectancy of 10 years!
  • In the Electro-Optical Sensor, or EOS Technology™, the gas flows between an Infrared transmitter and a receiver. The receiver detects the gas particles and communicates the level as a result. The advantage to this process is there are no parts to wear down and no physical cause for accuracy drifting. This benefits all calculations that are based on the measured value by maintaining a longer and higher level of accuracy.
  • Test for ambient CO Health Hazards within Residential or Commercial Applications. Detect and log ambient CO caused by a combustion appliance lacking proper venting, unsafe operation or improper installation. Also detect back drafting associated with negative pressure.
More Information
Weight 20.000000
Product Includes Combustion analyzer, flue probe, particle filter, carrying case, batteries and quick start guide/ manual
Specifications

• TF = Flue Temperature : Calculate net temperature in °F or °C. - Shows ambient temp after fresh air calibration and ‘ -OC- ’ when probe is disconnected. • T = Net Temperature : - Differential of flue temperature minus ambient (or inlet) temperature - Differential of T1 - T2 • T∆ = Temperature Differential : • O2 = Oxygen : O2 percentage displayed • CO = Carbon Monoxide : CO ppm (parts per million) displayed. - ‘ - - - - ’ or ‘ - OC - ’ is displayed if there is a fault with the CO sensor or the instrument has not been zeroed correctly, switch off instrument and try again. • CO2 = Carbon Dioxide: - EAGLE (C125 & C127) Calculated from the fuel selected and the measured O2 level - EAGLE (C125 & C127) Will display ‘ - - - - ’ or ‘ -O>- ’ if the O2 level is too high to calculate CO2 or in fresh air. - Calculated value is only displayed during the combustion test. - EAGLE X (C155 & C157) Direct measurement CO2 ppm (parts per million) displayed. • X = Excess Air: - Indicated as ‘ XAIR % ’ on the printout - A calculated percentage of O2 above the theoretical level required for complete combustion. - Is required to completely burn the fuel due to poor mixing and assisting in venting flue gases - Only displays a reading during combustion test. - ‘ - - - - ’ or ‘ -O>- ’ is displayed in fresh air. • EFF = Efficiency : - Calculated based on gas readings, net temperature and fuel selected. - Value is combustion efficiency, not appliance efficiency. • ∆ = Loss : - Total losses calculated from Combustion Theory. A summation of the next three parameters • Dry %: Calculated heat lost turning the Carbon in the fuel to Carbon Dioxide (CO2) • Wet %: Calculated heat lost turning the Hydrogen in the fuel into water (H2O) • CO Loss %: Calculated loss due to partially burnt Carbon. Any CO in the flue has the potential to be turned into CO2 releasing and losing more heat up the flue. • CO a = Carbon Monoxide Air-Free : Referenced to an oxygen level of 0%. - Do not confuse this reading with the actual CO reading as detailed above. - See the Combustion Efficiency Calculation sections for more details. • AMB = Air Inlet : - Temperature used to calculate the NET temperature. • CO/CO2 = CO/CO2 Ratio : The ratio of measured CO divided by CO2. - It gives an indication of: • How good a gas sample the instrument is reading. • How clean the boiler is running. - Example: A new or clean domestic boiler will display a ratio of less than 0.004, a unit in need of cleaning 0.004 - 0.008 and a unit needing a major overhaul will show at least 0.008. - Only displays a reading during combustion test. ‘ - - - - ’ is displayed while in fresh air. • D = Draft Pressure • P = Pressure • NO = Nitric Oxide : • -PO- = Pump Off : - Measured gases will display this when pump is off. • -O>- = High O2 level : - Calculated values will display this when O2 levels are greater than 18% - Values are calculated with fuel choice and the O2 reading

Power Supply Four 'AA' Batteries
Manufacturer UEI
MPN C155
Manufacturer Warranty 5 Years
upc code 00053533505856
You're reviewing: UEI Eagle2X Extended Life Combustion Analyzer Model C155
Your Rating